Construction
Ball seat type
Installation
Assembly Instructions:
1. Trim hose end with smooth square cut.
2. Lubricate either push-on fitting, hose or both.
3. Insert push-on fitting into hose until first barb is in hose.
4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.
Instructions
Disassembly instructions:
1. Leaving push-on fitting in place, make a 1″ cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.
Note
No hose clamps or ferrules are needed
Safety Notes
Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.
Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.
Specifications
Number of Barbs: 2
Barb Length: .77″
Barb Length: 1.02″
Number of Barbs: 3
Barb Length: 1.50″
Barb Length: .92″
Barb Length: .97″
