Features
Notch in nut for SAE identification
JIC only
Installation
Trim hose end with a smooth square cut.
Lubricate either Lok-On fitting, hose or both.
Insert Lok-on fitting into hose until first barb is in the hose.
Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from the end. Push with a steady force until the end of the hose is covered by the yellow plastic cap.
Assembly Instructions:
1. Trim hose end with smooth square cut.
2. Lubricate either push-on fitting, hose or both.
3. Insert push-on fitting into hose until first barb is in hose.
4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.
Note
No hose clamps or ferrules are needed
No hose clamps or ferrules are needed
Part is JIC only, may substitute dual angle. Contact Dixon.
Safety Notes
Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.
Lok-On fittings will properly grip Lok-On hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.
Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.
Specifications
2 barbs
Number of Barbs: 3
Length Centerline C: 3.26″
Length Centerline D: 1.81″
Number of Barbs: 2
Length Centerline C: 2.33″
Length Centerline D: 1.09″
Length Centerline C: 1.85″
Length Centerline D: .91″
Instructions
Disassembly instructions:
1. Leaving push-on fitting in place, make a 1″ cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.
